Designer iPhone 6 case for Apple iPhones are known for their durability and the extreme protection they provide to the enclosed device. The Designer case iPhone 6 from top to bottom and includes a built-in screen protector. Putting an iPhone in an Designer involves separating the layers of the case and then putting them back together with the iPhone inside. Once an Designer is on your iPhone, you should not need to remove the case very often.s
Push the tab on the Designer's holster and then pull the Designer out of the holster. Lift the silicone from one corner of your Designer and work your way around the case until the silicone is completely separated from the shell. Unhook each of the three clips that hold the two halves of the shell together. The clips are located on the left side, the right side and the top of your case. Insert the bottom of your iPhone into the front half of the Designer shell with the iPhone's screen facing the screen-protector. Snap the two halves of the shell back together so that the phone is encased in the Designer and the three clips are holding the two halves together. Insert the bottom of the shell into the hole in the front of the silicone and pull the top of the silicone over the top of the shell.
The Designer iPhone 6 cases the phone in several layers of silicone and leather to maximize protection from drops, scratches and other hazards. To put an iPhone in an Designer case or to take an iPhone out, you can open the case by peeling off the silicone skin and separating the two halves of the leather shell.